News

Refurbishment of a four-high rolling mill

Coiling of the roll stand before the rebuild

Coiling of the roll stand after the rebuild; with new run-out table, new coiler and new coil lift truck as well as new safety devices

3D-design of the rebuild

C-Technik achieved the full acceptance of a refurbishment project on an existing four-high rolling mill for narrow strip. In this step the rolling mill received a new run-out table including new separation arm for rewinding processing, a new recoiling unit with up-to-date drive technology and paper winder as well as a new coil car. Additionally we modernized the electrical and hydraulic equipment to current state-of-the-art technology. Finally C-Technik implemented new safety equipment to increase the working safety on the line.

All in all this refurbishment step results in a remarkable improvement of the mill. This is achieved by an increase in the possible rolling strip width, improvement of the safety level as well as new functions like recoiling from the bottom and unloading of the coil by coil car.

In case you are planning a refurbishment of an existing plant as well or if you are looking for support in developing reasonable extension steps for your rolling mill our experts are open to support you in any way.